Negative Waterproofing – New Construction

Negative Waterproofing – New Construction : This method of waterproofing could be used for some flat areas inside the building, e.g. parking lots, corridors or tunnels when the high level of water cause a damp and wet surface. This method is used only after the concrete is completely dried and cured and before going through the finishing phase of flooring.

In this method, the cementitious capillary crystalline waterproofing materials is applied to the surface in a thin layer in order to prevent the water penetration to the internal area and make the wet or damp surfaces, completely dry!

Please contact us for a Free Consultation and Free Estimate.

Planning the Work

Negative-side waterproofing is applied from the inside, on the side opposite the incoming water. If the water-facing side is still accessible during construction, it is worth comparing the two approaches before choosing a system. Before requesting an estimate, note where moisture appears, whether it changes after heavy rain, and when the flooring is scheduled. Photos of damp patches, cracks, and floor-to-wall joints can help show where the problem is concentrated. Cost and scheduling typically depend on the area to be treated, access to the concrete, the amount of surface preparation, and whether cracks or joints need separate repairs. Check the product’s application and curing requirements before setting a date for the flooring crew.

Questions

Does a damp floor always mean water is coming through the concrete?

No. Condensation and plumbing leaks can also leave a floor damp. Identifying the source helps determine whether a waterproofing treatment is appropriate.

Will a surface treatment stop water coming through a joint?

Not necessarily. Leaking joints and cracks may need separate treatment, especially where the concrete moves or water is actively flowing.

When can the floor finish go down?

Timing depends on the waterproofing product and the floor finish. Check both manufacturers’ requirements for curing, moisture, and compatibility before installing the finish.

Contact Dapcco

Call Dapcco at (647) 864-1383. Working hours are 8:00 AM to 6:00 PM on weekdays and 8:00 AM to 2:00 PM on Saturdays. Our address is 140 Doncaster Ave #5, Thornhill, ON L3T 1L3, Canada.